Self-made slyusary bream with their own hands

In order to make the slushy bream with your own hands, you need to know:

1. Zaryuvalny device.
2. Dril that drilled for metal or drilling verstat.
3. Anchor studs and bolts
4. Metal parts.

Pokrokove kerіvnitstvo for collecting yews.

For the cob you need a channel. Have a vikoristovuєtsya channel 100 * 50 * 290mm. Yak base will be stuck on a metal plate with a size of 200 * 200mm and a thickness of 10mm. On the internal height of the channel, the size of the tension is vibrated.

Our vipad has 38mm. So, on the inner side of the channel є it is rounded, and on the upper edge it is necessary to chamfer it. Dovzhina is 315mm wide, 20mm wide.

The sponges can be taken from the old people bream, if not, go to the old metal bars. Our vipadk has a size of 200 * 30 * 55mm. For a skin bar of sponges, a set of planks should be used. You should allow the sponges to be fixed at the required points.

For an unstable part of the size of the set bar, the width of the channel, which is used to fasten the bolt holes, for a height of 40mm.

For a ruhomo vikoristovuєmo I will set a bar in sizes 100 * 75 * 20mm. At the butt-end, there are holes, at the end, there is a hole in it. Wonderful for fixing the set bar on the shaft. A special washer is placed between the flat bar and the shaft. The other end of the shaft is screwed into the massive nut, as it can serve as a caddy.

From the flat bar to the nut on the shaft, two supports are spaced directly from the cylindrical openings in the middle. Їх size 45 * 45mm, the stench is easy to accommodate between later strains.


Gwent, our vipad stays at 550mm, cut 300mm with a head at the end of 55mm. Thread М24 croc 3. At the end, a hole for the handle is hardened. For gwent vikoristovuvsya metal rod with a diameter of 35mm.

Folding yews vimagan mіtsnogo mechanic script in front of zvaryuvannya. For whom you should know, open the door, and open it:

• to a non-talented inveterate bar that channel;
• I will break down the bar that later on;
• unruffy sponges up to the inveterate level;
• crumbled sponges to the inevitable bar.

The lips that hurt the slats are skirting into thin bolt-ons or pins. The shaft should be tightened firmly at the massive nuts. Vise vstanovlyuyutsya on a metal basis.

Shilno zvaryuyutsya at the seams: channel with a base, a massive nut, an indented bar and untidy sponges. Later, straighten with supporting straps, with a stubborn bar and rugged sponges.

The vise is zbirayayutsya by way of twisting the shaft, the tool is ready to use.

Video: how can you kill self-made bream?