Usunennya protokannya cover. Overhaul of the coating Hydro-insulation technology

On the other hand, all the inhabitants of the upper surfaces of the top-level surfaces, the rest of which have been raised for ten years, are faced with the problem of covering protection. Tse stosuєtsya vlasnikіv private budinkіv. Living behind a house cannot be called comfortable. At the same time, the middle side can be changed to the extent that the walls and steles are beaches, the tapestries go out, and the plaster coarsely. Allowances of vologosti can be the reason for the appearance of an unpleasant odor, fungus and fungus. This is not safe, and the stench often causes wiring faults.

The need to repair the cover when there is a problem

Once the beams are sagging, the stench may collapse, like a croquette. If it’s about covering the private booth, then the gentlemen are busy with the repair, and from the housing and communal sector, then the services are struggling with the problems. Before the ear, it is important to know how the cause caused the emergency situation. It is necessary to be aware of the technology of carrying out the robot.

See the cover protectors

Usunennya protokannya pokrovlі, but it will be deprived of that, as you find out, as you are struggling with a problem. Predicting protesters are called, like and fall off, which can lead to problems, among them:

• boards;
• snigov;
• dry;
• lazy.

The boards are visible for an hour or so after them. In a wide range of vipadku it is possible to create a covering flooring. In some cases the vertical connections are unsealed. If it is necessary to start with a flat cover, then you can let it go through the deformation of the base. Snegovi ties are tied with tannins sisu. Water freezes on overhangs, slopes and troughs, and the temperature rises below zero. In the midst of tsikh mіstyah, kryzhany, yak blocku vіdtіk rіdini, scho and become the reason for repudiation.

Dry leakage can be detected when condensate and wet heat insulation are established. Merekhtlivi protokannya is not tied with litter, the stench does not linger because of the fate that natural minds. The reason for the appearance of micro-problems in the material is the deterioration of the technology, as it was victorious when it was laid.

Usunennya prot_kannya bitumnoy cover of the bagatoperkhovoy booth

As long as you will be able to see how we can see through the cover, it will be necessary to get started, which is the material of the building block. Can be used for capital repairs. Local robots are carried out on new pokritty, de greater coverage has saved the exploitation of quality. For a whole lot of pocketed dilyanka, it is necessary to virizate the shmatok of the cover, having entered about 50 cm. The diru needs to be flooded with dark huma or polymeric mastic. If the pokrittya has ceased to be elastic, then the patches cannot be hidden, the leaks are constantly steadily growing at the young ones. At the end of the day, it’s old enough to clean up, and the cover kilim will change.

Usunennya z metal tiles

Repair of roofing from metal tiles may be necessary for improper installation or poor technology when covering a coating cake. It is important at the first stage to find out the cause of the defect, and if you can see it, you may be sealed and covered with an anticorrosive solution.

As soon as you put it on the cover, you can fill it with a lot, then replace the sheet with a single piece. Repair of roofing from metal tiles in some transmissions, the need to replace the screws, which have been replaced. І here їх change to new. The old cribs are dumb, the result is short-lived. As for covering the period of the boule, the materials are incorrect, it will be necessary to replace the cover.

Usunennya leakage of folded dakha butokvartirny booth

The installation of the cover of the private booth can be known in the same way, since the installation stage was filled with a Defect in a whole lot of problems. By the method of rolling the seams, it is possible to slip through the sticks, and the sticks can be crumbled with a bituminous sealant or silikonovy zasob. As an alternative to using metal tiles, it is possible to replace the sheets more and more, as an alternative solution is to use patches, which stand for additional self-supporting aluminum. Diyaty at tsomu can be done using the soldering method.

Usunennya leakage of roofing from tiles

Usunennya prot_kannya pokrovlі can be known at that vipad, if at the stage of installation the tiles were vicorized. The role of the main problem may be the appearance of tremors, when temperature drops occur for an hour. Such a problem can lead to breaking the rules of editing. If you cause a defect, then vibrate the type of repair robots. Thermal injection is not produced until the deformation of the bottle and its development, as well as the improvement of crooked design. Changing the number of items can be made using cementitious sticks.

If you call on the hydraulic insulation between the sieves and the crocs, then there will be more folding robots, the stench will transfer the dismantling of the tiles to be repaired. On the offensive stage, it is necessary to see that dilyanka of hydro-isolation, as it appeared as a poppy. When the patch is installed, it is necessary to fix it with a covering glue and mastic. The meister can install new or old fragments of the slats, and then renew the tiles. Such robots will transfer professional tips.

Preparation of tools and materials for overhaul

Overhaul of the coating can be done without the preparation of materials and tools. Among them are the following:

• gas burner;
• sealant;
• bitum mastic;
• vіnik;
• heat insulation;
• cover material;
• nіzh for opening ruberoid;
• cement for the preparation of the spacing for the screed;
• specialtyag.

Do not cheat on a blowtorch with a gas burner. For loading the material, it is not recommended to pick up the coat, as it will take more than an hour of effort to carry out the work.

Overhaul of the cover

Carry out overhaul repairs of the coating, if it is necessary to rebuild the bed, and local robots cannot be helped. In general, you will need to dismantle and replace the old. For the dismantling of the cover, there is the knowledge of the cement screed and the visible heat insulation.

It will be necessary to update the steam-insulating ball and to organize the water system. Maystri lay down the heat-insulating material, mount the virvi for the drain and install the cement screed. The surface of the painting is hanging, and the surface is far from being covered. The basis is to be covered with light or in a fire warehouse.

Recommendations for a major overhaul of my coat

As soon as there is a good quality coating, it is possible to carry out a major overhaul. In the old situation, it is necessary to dismantle it. For the sake of completing it is often a special possession, which is not deprived of knowledge, but I’m skipping into a roll of material. Yak another option is the vistupaє sokir, at which the handle from the tree is replaced by a metal one. Dovzhina will be assigned to the maister.

Yak only the surface of the bulwark is cleaned, it is necessary to reconsider, and it is necessary to reconstruct it at the end of the trough and indentation. If it’s dumb, then it’s not necessary to fill in the screed. In some cases, before pouring, heat insulation should be installed, as in the form of a pyoplast, as in some form of gravity. The surface should be covered with bitum, and with plvkoyu, yak blockuvatime viparovannya vologi.

The cement can be caught before the covering material is laid. More beautifully in tsyom vypadki v_ddati perevag sklovoloknu. As well as carrying out the first step with cardboard covers, it’s possible to see good technical features. The robot needs to be repaired from the lower edge of the dakhu. It is important to preserve the ten centimeters of blotting. Reckoning to lie down from the kuta schilu. Shvi is covered with bitum mastic. The ball will fill up for a day, so that you can start before the offensive. The seam in the front ball is not to blame for the seam of the offensive one.

Look out materials for the repair of the cover, you can vibrate only, pergamin chi ruberoid. Leather, from them, it is necessary to lay down the coat, which can be used for bituminous mastic. The paint on the surface is crumbled with stone and skimmed with a roller. Fakhivtsi often select materials of the new generation, even the stinks may still be easy to see, as it allows you to see through the production of seams in rows. Tse lower vitrati material.

Usunennya leak of slate cover

Repair of the cover can extend the term of exploitation of the material up to 10 years. More than a dozen rockies in that particular place were simply cleared from the saw and the brude. The surface of the offensive stage was covered with linseed oil. The tricycle was curled up with a cloth, yak before it was seeping through with an olyna farboy. Ushkojenu dilyanka farbuvali.

Usunennya prot_kannya pokrovlі supervodzhuvalosya farbuvannya dіlyanka, scho to be repaired, schob nadati dahu privabliviy viglyad. To finish often with a good mark, the whole area of ​​the cover was shaken with a headlamp, which є to finish with labor-intensive and ineffective. Literally 4 years later, it became obsolete.

Today's use of coating from slate is going to work for the technology, as transferring PVA glue and cement to the addition of reinforced sheet asbestos. Three parts of asbestos glue sum was sunk into 2 parts of vicorite cement. The glue is dispersed in front of the water at 1: 1. The Danish warehouse is applied to dilyanki, which can be repaired, and be rubbed in.

In order to reach the shortened effect, it is recommended to apply it in 2 balls or more. The whole method can be overwhelmed, like a pole, in that, during the repair, it will not get too much, but if it is correct to prepare the sum, manipulation will allow the term of exploitation to be continued for 8 years. However, it’s too hard to finish it shydko more firmly, that її bazhano virobiti stretching for 2 years, in order to get a gotuvati step forward, it may not be possible to call it a pass. Repairing such robots is necessary in bad weather. The price is tied together with that, which is more likely to be inflicted by the summons, which will make them more reliable.

The leakage of the cover behind the additional hydraulic insulation "Technoelast EMP 5.5"

Usunennya protokannya cover of a large apartment booth is often served this year from the vicistories of the hydroisolation "Technonikol". As soon as it’s about the material, the guesswork, it’s popular for this reason, it’s possible to achieve low water clay. For a wago tsei, I will not change the indicator 1% stretching for 24 years.

Hydroisolation "Technonikol" is small at the top of the bowl at the upper part, while the lower surface is small at the ball. When stretched out, the force in late and lateral strains is set to 600N and 400N as a matter of fact. The weight of one square meter is 5.6 kg. Tsya gidroizolyatsiya "Technonikol" can be boosted at the moment of cutting in the fringes of 40%. The heat resistance of the warehouse material is 100%.