Navisna shafka

I am going to send my shafka quickly from the old men of the gaps, which have been deprived of our life. We knew the shafka for the storage of the toilet paper, paper towels and bags for smitty, which are for the convenience of being taken in the country toilet. You can, obviously, buy it in the shops, ale, in a way, we didn't know the shaf of the little ones, in a different way, all one charge at the dacha robiti of nothing, in the third place, do not burn the surplus of pine trees, do not go, but in the economies of the gentlemen, all material is guilty of butti vicoristany, and, in a quarter, on the right, but it’s even simpler.

VIZNACHENNYA ROSMIRIV NAVISNO SHAFCHIKI

So, as at the scaffolds there will be only paper towels with a toilet paper, robbing them of great razmіrіv nemenosti. Put the paper rolls at once, freeze them in and out from the gaps of the sidewall of the shafka, as well as the lower and upper part.

Now the screws are used to secure the frame of the shafi. The boards didn’t burst; at the fasteners, the holes were firmly drilled with a thin drill and the screws were twisted in them. Our frame is ready.

The rear wall of the headboard is available from the lining. Narіzhemo shmatki, scho lost from budivnistva lining with a size of 34 by 28 cm and is inserted into one... Small carnations cut the back wall up to the frame of the shaf and, for some reason, rob the door.

DOORS NAVISNO SHAFCHIKI

Razmіtimo doors shafki - the stench of guilty butti with a size of 28 by 17 cm skin. So the yak board with a width of 17 cm ended up with us, it was brutally leather doors with two gaps. It’s necessary to do it with dowels and dowels at once from the carpentry glues, as they were robbed earlier. Writing everything is good.

Approximate doors to the naval shafka, as all of us vlashtovu, for some reason close them on the frame. For a wide range of overhead furniture hinges, which open the doors of the shafi on a 90 degree cut. Chotiri loops were bought in advance in a furniture store. Close the doors on the doors, open the openings to the diameter of the hinge, protruding 1 cm from the edge. Mi zrobimo tse with a special metal crown, yak to be fastened on a drill.

There is one aspect here. At the center of the crown, it is necessary to fasten a drill bit, but not to open holes in the required assembly. The alent thickness of our dough is only 2 cm, and the standard is a drill, which can be sold at once from a crown, more on top of it. As soon as it is victorious, then the doors are hard-pressed. The drill needs to be drilled with a grinder, so that the trochas protrude over the edge of the crown.

Now it is brutally viral at the door for a mm thick, the crown has pierced the tree, then, for sure, the drill bit and expensively viral to the end, approximately 1 cm.